To manually turn off the system
From any mode, press & hold the TOP button until the screen goes completely blank. This will take about 3
seconds.
To turn the system back on, just press and release the TOP button.
The system will be back in the “M” mode.
Power On:
Press & Release the TOP button to turn on the receiver (will be in “M” mode).
The unit will now start to search for updated information. If you scroll through the positions after a lengthy
shutdown (either powered off or asleep), the readings will be in the memory of the monitor from when it was last
turned off (the night before, the week before or whenever it was last active). It will take approximately 20 minutes to
update the pressures and temperatures.
You may also institute the Auto-search function (pages 29 & 30). In this case, all readings will go to 0 psi and
32F. If all is well, updated pressures and temperatures will be back within 10 to 20 minutes. Remember –
antennae up!!!
TIP: If when you press and release the TOP button the unit does not light up, it simply needs to be re-charged.
To Next Page
Loading...
Need help?
General
