5. Press and release the RIGHT button again and the front half (# 1-10) tire positions will disappear (back
half will be visible).
6. Press and release the RIGHT button a 3
rd
time and all 22 positions will be back.
7. That was for “practice”! Do it a couple of time to get a better understanding (feel) for the procedure.
8. TIP: disconnecting one section can only be achieved while that section is missing (not visible).
9. So, with “D” on the screen, press and release the RIGHT button until the section you want to disconnect
is missing.
10. At that point, press and hold the LEFT and CENTER buttons for 3 seconds. The normal “Monitoring
Mode” display will be back with one section of tires missing.
11. Don’t worry, they are still there, you just can’t see them. They have been temporarily disconnected from
the system.
“Reconnect Mode”
So, when you return from your brief (or lengthy) sojourn, you will want to get these tires back on the screen.
1. From the “M” mode press and hold the LEFT and CENTER buttons for 3 or 4 seconds (“D” shows in the
trailer).
2. Press and release the RIGHT button until all 22 tire positions are back...
3. Press and hold the LEFT and CENTER buttons again.
4. The previously disconnected tire positions will be back and the unit is back in the “M” mode.
To Next Page
Loading...
Need help?
General
