Replacing a Single Transmitter:
If you need to replace a single transmitter, first enter the “L” mode.
From the “M” mode, press and hold the Left and Right buttons until you see all 22 positions and the letter “L” on
the screen.
Press and release the Right button and navigate to the position you wish to replace. (Green light)
Press and hold the Center button until the green LED light at the top of the monitor turns red with a “- - - PSI.”
Attach the new transmitter (assumes you have already removed the old transmitter). The LED should turn Green
within 10 to 15 seconds. If not, check that a fresh battery is installed in the replacement.
Exit from the “L” mode the same way you entered, press and hold both the Left and Right buttons until the 22
tires disappear and you see the letter “M” on the screen.
Voila, your new transmitter is installed!
To Next Page
Loading...
Need help?
General
