When to delete:
If you think you’ve screwed up the installation and want to start over.
If someone has removed all the transmitters and you don’t know which goes where.
If you are making a major change in RVs and the wheel positions need to be moved (5
th
wheel
to coach or reverse).
You’ve got nothing better to do and just want to re-install the system!
Here’s how:
1. From the “Monitoring Mode (M),” press and hold the Left and Right buttons for 5 seconds (until all 22
positions appear). The screen will show an “L”.
2. You will see that all your currently active tire position circles are filled in.
3. Press and hold the Center and Right buttons. The unit will beep twice and the circles will be empty
4. Since you are already in the “Learn Mode,” you may start the re-install process immediately (pages 21 &
22.)
5. If you are not ready, you should exit from this mode by pressing and holding the Left and Right buttons
until all 22 positions disappear.
6. You will be back in the “M” mode from which you may start over at any time. All previously installed
transmitter codes will have been erased. However, your previous baseline pressures will still be intact.
To Next Page
Loading...
Need help?
General
