Likewise on the underside of a 5
th
wheel king-pin works nicely.
TIPS:
It must be powered 24/7.
It should not be powered on by the ignition or any other switch. It only draws 24mA so is not a
significant drain on your electrical system.
We have seen some wired with a cigarette lighter adaptor but really do not recommend this as they are
subject to slipping out of the socket due to vibration of the rig. This is not readily noticed and could
cause a loss of signal due to the booster not being powered.
If hauling a travel trailer, try locating it closer to the front of the trailer.
The unit is fully weatherproof so external mounting is acceptable.
Check out our web site. There are several photos from some of our users which may help.
www.MinderResearch.com. If you have an idea you would like to share, please send it to us. You guys are the
experts and we love to hear from you - good or bad (geeze can’t believe that got in the book!!!).
“Starting Over” Full Delete Mode:
When implemented, this will delete computer codes from all transmitters that had been mounted. It is activated
from the “Learn Mode (L)”. When complete, all 22 tire position circles will be empty whereas previously the active
positions were filled in.
TIP: Even though the transmitter codes will be deleted, your baseline pressures will remain unchanged.
To Next Page
Loading...
Need help?
General
