So, the monitor is on (charged), the booster is wired up, and the batteries are installed
in the transmitters. You are now ready to attach the transmitters to the valve stems
and “LEARN” them to your monitor.
LEARN MODE (“L” on the screen)
With an “M” showing on the screen, press and hold the
right and left buttons for 5 seconds. When all 22 tire
positions appear, let the buttons go. You will see an “L”
on the screen. That stands for?? Right – Learn!
Pro-Tip: For better understanding, read page 22, 23 & 24
before proceeding.
Two things to note in this “L” mode are the solid blinking
circle and the red light at the top. The solid blinking circle
indicates the current tire position and the red light tells us no transmitter has been
“Learned” to that location.
To “Learn” a transmitter, press the right or left button to scroll to the position you
want. Once there, attach a transmitter to that tire’s valve stem. The light will turn
green (within 5 to 20 seconds) and you will see that tire’s pressure on the top of the monitor. Congratulations!
To Next Page
Loading...
Need help?
General
