“Learn Mode” (L) Detailed:
The following description describes a monitor with no tire positions “learned” (all tire position circles will be
empty). If positions have transmitters already dedicated, they will be filled in.
From “M” Press and hold Left and Right buttons
simultaneously (that’s like at the same time – EH?). When you
see all 22 positions, release the buttons.
The front left tire position will flash, the light on the top will be
red and you will see a “- - - PSI” on the screen. If you plan on
monitoring this position, proceed below. If not, press the Right
button and scroll to the first tire position as you laid out in
pages 24, 25, & 26 (Baseline Pressure Layout).
Mount any transmitter on your desired location indicated on the screen. LED will turn GREEN and the PSI will be
displayed within 30 seconds. If the screen has gone dark (at any time), simply press and release the center button
to see the numbers.
If synchronization is not achieved (light stays red), remove the transmitter for 10 seconds and re-mount. It’s also
a good idea to have the receiver close by with ANTENNA FULLY EXTENDED.
Press the Left or Right button to move to the next tire position.
Quick-Tip:
Unlearned positions will have a red LED
with a “- - - PSI” at the top. Learned
positions will have a green LED and show
you that tire’s pressure.
To Next Page
Loading...
Need help?
General
