10-10 Optional Installation/Assembly
7. The installation is completed after the right/left side panels and the rear cover are assembled.
10.2.5 4D Assembly
The disassembly tool: cross-headed screwdriver (M3, M4), anti-electrostatic glove
1. Remove the left side panels (refer to chapter 9.3.2 step 1).
2. And remove engine board.
3. Fix 4D assembly to corresponding positions on engine board with four M3 X 8 screws.
4. Insert engine board into corresponding slot. Fix the plastic clips. Assemble the left side panel.
Then, the installation is completed.
To Next Page
Loading...
Need help?
General
