Care and Maintenance 12-7
â—¼ Tool: dry soft cloth, soft brush, mild soap-suds
â—¼ Method:
a) Use soft dry cloth to clean off the dust on probe and gel holder and its gap; use the soft
brush to clean off the dust from gaps and probe holders of smaller intracavity probes.
b) If there are ant stains, remove the probe holder. Use mild soap-suds to clean off the
stains. Re-install it after being air dried.
c) Gel heater: unplug the cable of gel heater, and take off the heater. Use the mild
soap-suds to clean the heater. Use soft brush to clean the holes. Use soap-suds to
clean off the stains, and re-install it after air-dry.
7. Device cover cleaning
â—¼ Tool: dry soft cloth, mild soap-suds
â—¼ Method:
Use soft cloth to clean off the dust on the device cover (the part exposed).Or use mild
soap-suds to clean off the stains, and air dry it.
NOTE: it is preferred to use soft brush to clean off the dust on the port or socket rather than wet
cloth (such as probe socket, IO board and ports and sockets on power supply board).
12.2.2 Peripherals Cleaning
Perform the cleaning according to the reality. The test items without the configurations can be
ignored.
Table 12-4 List for peripherals cleaning
Use soft dry cloth to clean off the dust and stains on the
cover. Remove the cover to clean the internal of the printer. It
is necessary to abide by the operation procedures in
Operator’s Manual to clean the printer.
Use soft dry cloth to clean off the dust and stains on the
cover. Remove the cover to clean the internal of the printer. It
is necessary to abide by the operation procedures in
Operator’s Manual to clean the printer.
Use dry soft cloth to clean the glass board of the scanner,
and the clean off the dust on the cables and the bracket.
Please abide by the operation manual on the scanner to
perform the cleaning.
To Next Page
Loading...
Need help?
General
