C-10 Barcode Reader
5. Hold the trigger until the digital imager reader beeps, indicating the barcode is successfully
decoded.
NOTE: Steps 2 - 4 may be required to repeat on poor quality or difficult barcodes.
The aiming pattern is smaller when the digital imager reader is closer to the symbol and larger
when it is farther from the symbol. Scan symbols with smaller bars or elements (mil size) closer to
the digital imager reader, and those with larger bars or elements (mil size) farther from the digital
imager reader.
The digital imager reader can also read a barcode presented within the aiming dot not centered.
The top examples in show acceptable aiming options, while the bottom examples cannot be
decoded.
C.3 JADAK Barcode Reader
C.3.1 Supported Barcode Reader Model
The Ultrasound System supports the following barcode readers: HS-1M JDK-2413 and HS-1R JDK-
2601.
C.3.2 Operating System Version
If you need to use the JADAK barcode reader with the Ultrasound System, ensure that the operating
system version is 3.9.8 or later versions. If the version is lower than the requirements, please upgrade
the operating system.
For version upgrading, contact the Mindray service engineers. Select [Setup]→[About]→[About
Details]→[Operating System Version] to check the operating system of your device.
C.3.3 Setting Up the JADAK Barcode Reader (Taking HS-1R
as an Example)
1. Turn off the power to the Ultrasound System;
2. Connect the appropriate interface cable to the barcode reader;
3. Plug the other end of the cable into a free USB port on the Ultrasound system;
To Next Page
Loading...
