Mindray TE7T - Page 305

Barcode Reader C-11
4. Once the imager has been fully connected, power on the Ultrasound System.
C.3.4 HS-1M JDK-2413 Configuration
The barcode reader is configured through scanning the barcode. Ensure that the barcode reader is
properly connected to the Ultrasound System before scanning. After the barcode is successfully
scanned, the barcode reader buzzes, and the green indicator is On.
 Configuration before use
1. Scan the following 1-D barcode to configure the barcode reader:
2. Scan the following 2-D barcode to enable the suffix:
3. Scan the following 2-D barcode to set the suffix to Enter:
 Reset the barcode reader
1. If the barcode reader is in malfunction, scan the following 1-D barcode to reset to default settings.
2. Follow the configuration steps above to reconfigure the barcode reader.
C.3.5 HS-1R JDK-2601 Configuration
The barcode reader is configured through scanning the barcode. Ensure that the barcode reader is
properly connected to the Ultrasound System before scanning. After the barcode is successfully
scanned, the barcode reader buzzes, and the green indicator is On.
 Configuration before use
1. Scan the following 1-D barcode to configure the barcode reader:
2. Scan the following 1-D barcode to enable the suffix:
For scanning Barcode
For scanning RFID
Notes:
Users can customize the JADAK barcode reader based on