Minelab F3

F3 Service Manual
Page 64
Ensure that the pressure block does not protrude too far into the shaft. If required,
push it back into the camlock body otherwise difficulty may be encountered when
fitting the lower shaft.
Figure 68: Pushing Pin Cam Lever in.
 Check the middle camlock operates correctly.
 Open the cam lever middle.
f. To Reassemble the Camlock Lower and Lower Shaft:
 Position the cam lever then push the pin lower camlock into the camlock body.
Open the lower cam lever. Place the lower pressure block into the lower
camlock body. Refer to Figure 69.
Figure 69: Inserting Pressure Block Lower into Camlock Lower.
 Slide the lower shaft through the upper/middle shafts, protruding section at front
of the lower shaft uppermost. Shown in Figure 71.