Minelab F3

F3 Service Manual
Page 65
Figure 70: Inserting the Lower Shaft.
 Holding the detector and lower camlock assembly upside down (to prevent the
lower pressure block falling out) slide the camlock lower fully onto the lower
shaft with a twisting motion.
Figure 71: Connecting the Camlock Lower to the Lower Shaft.
 Turn the detector back over and ensure that the lower camlock assembly is
positioned on the lower shaft with the cam lever uppermost.
 Push the pin into the camlock lower. Shown in Figure 72.
Figure 72: Inserting Pin Lower Camlock.
Protrusion on
Lower Shaft