miniDSP Flex Eight - Remote Control

3/15/23, 9:47 AM
Print or save - miniDSP Flex Eight
https://docs.minidsp.com/product-manuals/flex-eight/print_page.html
35/75
Remote control
The miniDSPFlexEight has several options for remote control of key runtime functions.
The miniDSPFlexEight has several options for remote control of key runtime functions.
Using the miniDSP remote
The infrared remote control provided with the miniDSPFlexEight controls all key runtime functions.
Standby
Put the miniDSPFlexEight into standby and take it out again.
Mute
Mute and unmute audio output.
Volume
Reduce or increase the volume. Each press changes the volume by 0.5 dB. Holding
down a button will accelerate volume change to 3 dB steps.
Media control
Have no effect with the FlexEight.
DiracLive
Enable or disable DiracLive ltering. Has an effect only if the miniDSPFlexEight is
upgraded with DiracLive.
Source selection
Cycle through the available input sources in order: TOSLINK, SPDIF (coax), USB,
Bluetooth.
Preset (1 through 4)
Switch to the selected preset. It will take a few seconds for the preset selection to complete while the
processor loads the new lters from its ash memory into the DSP.
Using a third-party programmable remote
A third-party programmable remote can be used with the miniDSPFlexEight. Use the remote codes listed below.