miniDSP Flex Eight - Two-Way Active Speaker

3/15/23, 9:47 AM
Print or save - miniDSP Flex Eight
https://docs.minidsp.com/product-manuals/flex-eight/print_page.html
46/75
Typical connections for subwoofer integration with the miniDSPFlexEight
The routing for this system is:
INVERT
0 DB
Right In
INVERT
0 DB
Left In
0 DB
INVERT
INVERT
0 DB
Right Out
Left In
0 DB
INVERT
0 DB
INVERT
INVERT
0 DB
0 DB
INVERT
INVERT
0 DB
0 DB
INVERT
INVERT
0 DB
0 DB
INVERT
INVERT
0 DB
Left Out
Right In
INVERT
0 DB
INVERT
0 DB
Left In
INVERT
0 DB
Right In
Sub
Right In
UnusedUnusedUnusedUnusedUnused
Left InLeft InLeft InLeft InLeft In
Right InRight InRight InRight InRight In
The left and right inputs are sent to outputs 1 and 2. Both inputs are summed and sent to output 3. Outputs 1 and 2
will usually have a high pass crossover lter to remove the sub frequencies, and output 3 will have a low pass
crossover lter.
Two-way active speaker
The diagram below shows the connections for a two-way active speaker. Amplication can be either a multichannel
amplier, or a pair of stereo ampliers.
2 x stereo or
1 x multichannel
power amplifier
1
2
3
4
Left
woofer
Left
tweeter
Right
woofer
Right
tweeter
Protection
capacitor
Input sources
5
6
7
8
No connection
(or use for one
or more subwoofers)
miniDSP
Processor
Typical connections for a two-way active speaker using the miniDSPFlexEight
The routing for this system is: