19
7. Press [
䊳
/D-OUT] as necessary, so that the digit you want to set
next starts blinking (becomes active).
8. Press [▲] or [▼] as necessary to change the value of the active
digit.
9. Repeat steps 7 and 8 as necessary to set values for all digits.
◆ When you have entered values for all digits, the entire
value (all digits) will blink.
● You can cancel the entry procedure by pressing [CALL].
5. Press [
䊳
/D-OUT].
◆ One or more decimal points begin blinking.
● If a target value is already set for this parameter, the
value is displayed. The value’s decimal point blinks.
● If the set target value does not have a set decimal point,
all three of the line’s decimal points blink.
6. Press [▲] or [▼] as necessary to select the number of significant
digits for the selected parameter.
● If you use the [▲] key, the number of digits changes as
shown in the illustration. If you use the [▼] key, the ac-
tion moves in the reverse direction.
● When you are ready to move to another line, return to Step 4.
To enter a value for Ev, x, y, or z
To Next Page
Loading...
