18
2. Press [∆].
◆ The display shows color-difference parameters.
3. Open the slide cover, and press [SET].
◆ The CHROMA METER enters SET mode, and waits for
you to begin keying in the target values. The display con-
tent varies according to whether target values have al-
ready been stored, as follows.
● If no target is currently set, the display shows 0’s for all
parameters (where the number of digits varies according
to the parameter). The first line is blinking.
● If you have previously set a target, the target values are
shown. The first line is blinking.
4. Use [▲] or [▼] to select the parameter (the line) you wish to set.
● The digits on the selected line blink.
● Press [▲] or [▼] as necessary to move the blinking indi-
cation to the line you want to set.
● You can now enter a value for the selected line (parameter). Note that some parameters
also allow you to set the number of significant digits. The entry method varies according to
whether significant digits can or cannot be changed. To set a value for Ev, x, y, or z.
proceed from Step 5 below. To set a value for x, y, u’, or v’, proceed from Step 10.
To Next Page
Loading...
