20
To enter a value for x, y, u’, or v’
10.
Press [
䊳
/D-OUT] as necessary, so that the digit you want to set
next starts blinking (becomes active).
11
. Press [▲] or [▼] as necessary to change the value of the active
digit.
12.
Repeat steps 10 and 11 as necessary to set values for all digits.
◆ When you have entered values for all digits, the entire
value (all digits) will blink.
● You can cancel the entry procedure by pressing the
[CALL] key.
13
. Repeat steps 4 to 12 as necessary to set values for all param-
eters.
● You can cancel the entry procedure by pressing the
[CALL] key.
14
. Recheck you entries to be sure that they are correct, and then
press [SET] to register them.
◆ The CHROMA METER writes the entered values into
the target memory, so that they become the target val-
ues.
● You can view the currently set target values by pressing [CALL].
● If any of the values you have entered are outside of the permissible range for the corre-
sponding parameter, the CHROMA METER displays the “Err A” error message and then
cancels SET mode (without registering any of the entered values).
To Next Page
Loading...
