28
5. Press [▲] or [▼] as necessary to select the number of significant
digits.
● If you use the [▲] key, the number of digits cycles as
shown in the simplified illustration at left. If you use the
[▼] key, the action moves in the reverse direction. (The
actual display will show the measurement results held at
step 1-3 above. The illustration shows all 0’s so that the
action is easier to see.)
6. Press [
䊳
/D-OUT] as necessary, so that the digit you want to set
next starts blinking (becomes active).
7. Press [▲] or [▼] as necessary to change the value of the active
digit.
8. Repeat steps 6 and 7 as necessary to set values for all digits.
◆ When you have entered values for all digits, the entire
value (all digits) will blink.
● You can cancel the entry procedure by pressing [CALL].
● When you are ready to move to the next line, return to Step 3.
Entering the correct x or y value
9. Press [
䊳
/D-OUT] as necessary, so that the digit you want to set
next starts blinking (becomes active).
10
. Press [▲] or [▼] as necessary to change the value of the active
digit.
To Next Page
Loading...
