29
11
. Repeat steps 10 and 11 as necessary to set values for all digits.
◆ When you have entered values for all digits, the entire
value (all digits) will blink.
● You can cancel the entry procedure by pressing [CALL].
12
. Repeat steps 3 to 11 as necessary to set the correct values for all
three lines.
● You can cancel the entry procedure by pressing [CALL].
13
. Recheck you entries to be sure that they are right, and then press
[SET] to register them.
◆ The CHROMA METER computes the CF values by com-
paring your entered values with the held measurement
values.
● If any of the computed CF values is lower than 0.0001 or higher than 10.0000, the CHROMA
METER displays the “Err A” message and forcibly cancels SET mode.
● You can view CF values by pressing [CF] (to enter CF mode) and the holding down the
[CALL] key. The values remain on the screen until you release the key.
● If any of the values you have entered are outside of the permissible range for the corre-
sponding parameter, the CHROMA METER displays the “Err A” error message and then
cancels SET mode (without registering any of the entered values).
● If you attempt to set y such that y < 1-6.98x, the CHROMA METER displays the “Err A”
message and forcibly cancels SET mode.
To Next Page
Loading...
