Minolta DI450 - Page 177

6-10
3. When the Message “Stapler is empty.” Appears
When a Message Appears
Chapter 6
Holding the Grip, slide the Finisher away
from the machine.
<Only when the Finisher FN-105 is mounted>
Open Right Door [FN7].
Turn the dial to the left to move the Staple
Unit (two Stapler Units in FN-105) toward
the center.
Pull the Staple Cartridge out to the front.
<Finisher FN-105>
NOTE
Two Staple Cartridges are mounted in Finisher
FN-105. Be sure to remove the specific Staple
Cartridge that is indicated in the message on the
Touch Panel.
<Finisher FN-106>
<Finisher FN-105>
Pinch the portions of the Staple Cartridge
marked with “Push” to pop up the upper part
of the cartridge and remove the empty staple
clip.
<Finisher FN-106>
Remove the empty staple clip from the
Staple Cartridge
.
Finisher FN-105/Finisher FN-106
1
4002O175AC
2
4002O176AB
3
4002O177AB
4
4002O178AA
Stapler #2 Stapler #1
4002O179AD
Stapler #1
5
4002O362AA
4002O180AB