6-11
3. When the Message “Stapler is empty.” Appears
When a Message Appears
Chapter 6
<Finisher FN-105>
Load a new staple clip in the Staple Cartridge
and return the upper part of the cartridge
back again.
Gently peel off the stopper seal.
<Finisher FN-106>
Load a new staple clip into the Staple
Cartridge and carefully peel off the Seal.
InsertthenewStapleCartridgeuntilaclick
is heard.
<Finisher FN-105>
<Finisher FN-106>
<Only when the Finisher FN-105 is mounted>
Close Right Door [FN7].
Slide the Finisher back against the machine.
Touch [Staple] shown on the Touch Panel
and the machine automatically feeds a sheet
of paper to test the stapling.
Remove the sheet of paper to check that it
has been properly stapled.
* If no staples are evident, clear the staple
misfed.
“Clearing the Staple Misfeed.” ☞ p. 6-40
NOTES
• Reload the Staple Cartridge only after you are
prompted to do so by the message. Removing
the Staple Cartridge before then will result in
stapling trouble.
• After a new Staple Cartridge has been installed,
be sure to run a test-stapling sequence to
ensure that staples are properly driven into the
paper.
6
4002O363AA
4002O181AC
7
4002O182AA
4002O183AD
8
4002O184AB
9
1
4003P188CA
11
4002O186AC
To Next Page
Loading...
