FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
S-22
[Service Mode Tech. Rep. Choice]
Choice No.
Setting (The default is .)
Select either PM Counter or Copy Kit Counter.
NOTE
If this function is set to “2,” the copier gives an indication to replace
the IU and inhibits the initiation of a new copy cycle even if C-4 is set
to “0.”
C-6
✽✽
For 18/23 cpm
Copier only
<Plug-In Counter Copying Enable/Disable>
Select whether to enable or disable copying according to whether the
Plug-In Counter is plugged in or not.
NOTE
Be sure to set this function to “1” when the Plug-In Counter is
installed.
C-7 <IU 60K Stop>
Select whether or not to inhibit copying when IU Counter has counted
60K.
Default: 0 (inch areas) / 1 (metric areas)
C-15 <Toner Empty Stop>
Select whether or not to inhibit copying when a toner-empty condition
is detected.
NOTE
If “1” is set, the copier inhibits copying when it detects a T/C of 3.5%
or lower.
Highlighted
Data Description
PM Counter
1
Copy Kit Counter: Copying not inhibited after the
counter has counted down to zero.
2
Copy Kit Counter: Copying inhibited after the counter
has counted down to zero.
0
Data 1
Description
Permits copying even
when the Plug-In Counter
is not plugged in.
Inhibits copying when the
Plug-In Counter is not
plugged in.
0
Data 0 1
Description Permits copying. Inhibits copying.
Data 1
Description Permits copying. Inhibits copying.
0
To Next Page
Loading...
