Minolta EP1085 - 13-2.Drawer Positioning; 13-3.Paper Lifting Plate

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 MECHANICAL/ELECTRICAL
98.04.24
M-45
1174SBM1302A
Each of the 1st and 2nd Drawers is positioned by fitting its Positioning Plate on the paper
take-up end into the groove in the Drawer Frame. It is then secured in position by the mag-
net installed in the Drawer Front Cover on the paper take-up end. The tabs on both sides at
the front of the Drawer ensure that the Drawer clicks into position. Any deviation in the
paper path reference position can be adjusted within ±2 mm by moving the Front Cover of
theDrawertothefrontorrear.
1174SBM1303A
The Paper Lifting Plate of each Drawer is raised at all times by two Paper Lifting Springs.
For the 2nd Drawer, the type and position of the Paper Lifting Springs must be changed
according to the paper size. (For details, see DIS/REASSEMBLY, ADJUSTMENT.)
13-2. Drawer Positioning
13-3. Paper Lifting Plate
1139M056AA
Positioning
Plate
Tab
Rear End
Front End
Position
Plate
1139M057AA
1151M024AA
Paper Lifting Plate
1139M058AA
Paper Lifting Springs