FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 GENERAL, MECHANICAL/ELECTRICAL
98.04.24
M-46
1174SBM1304A
The copier detects that the Drawer is slid into position as follows.
1st Drawer
When the 1st Drawer is slid into the copier, the Drawer Frame presses the 1st Drawer Set
Detecting Switch installed on the back panel of the copier.
2nd Drawer
When the 2nd Drawer is slid into the copier, the Rib on the Drawer Frame blocks the 2nd
Drawer Set Sensor.
<Control>
13-4. Drawer-in-Position Detection
Control Signal ON OFF WIRING DIAGRAM
S65 PWB-A PJ15A-11 L H 15-B
Control Signal Blocked Unblocked WIRING DIAGRAM
PC69 PWB-A PJ2A-2 L H 17-A
2nd Drawer Set Sensor PC69
S61
Drawer Frame
1139M061AA
Paper Size
Detecting Switches
1st Drawer Set
Detecting Switches S65
1139M060AA
S62S63
To Next Page
Loading...
