Minolta EP1085 - 2 PRECAUTIONS FOR INSTALLATION; Installation Site; Power Source

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 GENERAL, MECHANICAL/ELECTRICAL
98.04.24
G-10
1174SBG0200A
Installation Site
To ensure safety and utmost performance of the copier, the copier should NOT be used in a
place:
• Where it will be subject to extremely high or low temperature or humidity.
• Which is exposed to direct sunlight.
• Which is in the direct air stream of an air conditioner, heater or ventilator.
• Which puts the operator in the direct stream of exhaust from the copier.
• Which has poor ventilation.
• Where ammonia gas might be generated.
• Which does not have a stable, level floor.
• Where it will be subject to sudden fluctuations in either temperature or humidity. If a cold
room is quickly heated, condensation forms inside the copier, resulting in blank spots in
the copy.
• Which is near any kind of heating device.
• Where it may be splashed with water.
• Which is dirty or where it will receive undue vibration.
• Which is near volatile flammables or curtains.
Power Source
Use an outlet with a capacity of 115V, 1.18KW or more, or 120V, 1.22KW or more, or 120-
127V, 1.29KW or more, or 220
–240V, 1.27KW or more.
• If any other electrical equipment is sourced from the same power outlet, make sure that
the capacity of the outlet is not exceeded.
• Use a power source with little voltage fluctuation.
• Never connect by means of a multiple socket any other appliances or machines to the
outletbeingusedforthecopier.
• Make the following checks at frequent intervals:
✽ Is the power plug abnormally hot?
✽ Are there any cracks or scrapes in the cord?
✽ Has the power plug been inserted fully into the outlet?
✽ Does something, including the copier itself, ride on the power cord?
• Ensure that the copier does not ride on the power cord or communications cable of other
electrical equipment, and that it does not become wedged into or underneath the mecha-
nism.
Grounding
To prevent receiving electrical shocks in the case of electrical leakage, always ground the
copier.
• Connect the grounding wire to:
✽ The ground terminal of the outlet.
✽ A grounding contact which complies with the local electrical standards.
• Never connect the grounding wire to a gas pipe, the grounding wire for a telephone, or a
water pipe.
2 PRECAUTIONS FOR INSTALLATION