Minolta EP1085 - 7 Function Setting Requirements at Replacement of Parts

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 SWITCHES ON PWBs/TECH. REP. SETTINGS
98.06.09
S-34
• If a part is replaced as part of troubleshooting and other service jobs, some parts require
that a Test operation be run and data values reentered and/or cleared.
❍ : Required
✽
1 : Including the replacement of the ATDC Sensor.
✽
2 : Including the cleaning of Lamp Regulator and optical system.
7 FUNCTION SETTING REQUIREMENTS AT REPLACEMENT OF PARTS
RAM
Board
IU
PC
Drum
Developer
✽
1
Cleaning
Blade
Fusing
Rollers
Exposure
Lamp
✽
2
Memory clear ❍
Initialize ❍
Job program ❍
User mode ❍
Tech.Rep.Choice ❍
Test F3 ❍❍
Test F5 ❍❍
Test F8 ❍❍ ❍
PM Counter ❍
Clearing Parts/
Supplies Life
Counter “Pc”
❍
Clearing Parts/
Supplies Life
Counter “St”
Clearing Parts/
Supplies Life
Counter “Cb”
❍
Clearing Parts/
Supplies Life
Counter “Fu”
❍
Adjust mode ❍
Replacement Part
Function
Service mode