Minolta EP1085 - Page 134

FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 DIS/REASSEMBLY, ADJUSTMENT
98.04.13
ii
(7) Replacement of the Ozone Filter .....................................................D-39
2-8. FUSING UNIT ..........................................................................................D-40
(1) Removal of the Fusing Unit .............................................................D-40
(2) Cleaning of the Pre-Fusing Guide Plate ..........................................D-41
(3) Removal of the Upper Fusing Roller ...............................................D-41
(4) Cleaning of the Upper Fusing Roller ...............................................D-43
(5) Cleaning of the Upper Paper Separator Fingers .............................D-43
(6) Cleaning of the Fusing Thermistor ..................................................D-43
(7) Removal of the Lower Fusing Roller ...............................................D-43
(8) Cleaning of the Lower Fusing Roller ...............................................D-44
(9) Cleaning of the Lower Paper Separator Fingers .............................D-44
(10) Disassembly of the Exit/Duplex Switching Unit (Option) .................D-45
3. ADJUSTMENT .................................................................................................D-49
3-1. JIGS AND TOOLS USED ........................................................................D-49
3-2. ADJUSTMENT REQUIREMENTS LIST ..................................................D-50
3-3. ADJUSTMENT OF SWITCHES ...............................................................D-51
(1) Adjustment of Front Door Interlock Switch S21 ...............................D-51
3-4. ELECTRICAL/IMAGE ADJUSTMENTS ..................................................D-52
(1) Adjustment of the Maximum Exposure Lamp Voltage for
the Manual Mode .............................................................................D-52
(2) Adjustment of the Optimum Exposure Setting in the Manual Mode D-55
(3) Adjustment of the Optimum Exposure Setting in the Auto Mode ....D-56
(4) Adjustment of the ATDC Sensor .....................................................D-57
(5) Adjustment of the Aperture Blades ..................................................D-58
(6) Adjustment of the Multi Bypass Table Reference Position ..............D-59
(7) Adjustment of the 1st/2nd (23 cpm copier only)
Drawer Reference Position ..............................................................D-60
(8) Adjustment of the Paper Lifting Plate Springs (2nd Drawer):
23 cpm copier only ..........................................................................D-61
(9) Adjustment of the Leading Edge Registration .................................D-62
(10) Adjustment of the Image Leading Edge Erase Width ......................D-66
(11) Adjustment of the Image Erase Lamp Position ...............................D-68
3-5. OTHER ADJUSTMENTS .........................................................................D-69
(1) Adjustment of the Scanner/Mirrors Carriage Position .....................D-69
(2) Adjustment of the Gap Between the Doctor Blade and
Sleeve Roller ...................................................................................D-70
(3) Adjustment of the Original Size Detecting Board ............................D-71
4. MISCELLANEOUS ..........................................................................................D-72
4-1. INSTALLATION OF THE PLUG-IN COUNTER MOUNTING BRACKET
(OPTION) .................................................................................................D-72