FrameMaker Ver.5.5(PC) EP1054/EP1085/EP2030 TROUBLESHOOTING
98.05.15
T- 1 6
Copier Take-Up Misfeed Clearing Procedure
Continued on next page
Symptom
Step
Check Item
Result
Action
• Paper is not
takenupatall.
• Paper is station-
ary before the
Paper Take-Up
Sensor.
1
Does the paper being used
meet product specifica-
tions?
NO
Instruct the user to use the
paper that meets product
specifications.
2
Is the paper curled, waved,
or damp? YES
Change the paper.
Instruct the user in how to
store the paper.
3
Are the Separator Fingers
on both sides of the Drawer
in position?
NO
Instructtheusertoloadthe
paper so that it rests under
the Fingers.
4
Are the Separator Fingers
deformed?
YES
Replace the Fingers.
5
Is the Trailing Edge Stop or
Edge Guide in good posi-
tion?
NO
Instruct the user in how to
position the Edge Stop or
Guide.
6
Are the Paper Lifting
Springs positioned cor-
rectly?
NO
Change the position of the
Springs or add one as nec-
essary.
7
Are the Paper Take-Up
Rolls deformed, worn, or
dirty with paper dust?
YES
Clean or replace the Paper
Take -Up Rolls.
8
Is a signal being output
from PWB-A to the Paper
Take-Up Solenoid?
✽ Does the voltage across
PJ4A-9 (1st Drawer) or
PJ3A-2 (2nd Drawer) on
PWB-A and GND change
from DC24V to DC0V
when the Start Key is
pressed?
YES
Adjust the Solenoid stroke.
Check the Solenoid.
NO
Replace PWB-A.
9
Is the Clutch Spring
deformed or worn?
YES
Replace the Clutch Spring.
To Next Page
Loading...
