8
CLEANING MODES
1. REGULAR
SCRUB MODE
When the machine
is running in this
mode, the machine
will perform all
operations. This
mode can be used
for day-to-day tasks
under normal
conditions. When
the operator sets the
directional switch to
forward and
activates the
accelerator handle, the solution pump will turn on, the brushes will turn on and be lowered to
the floor, as well as the rear squeegee. While operating in this mode, the solution will be
dispersed into the brushes, which will scrub the floor allowing the chemical in the solution to
break down the dirt on the floor. As the machine continues to move forward, the rear squeegee
and vacuum system will recover the dirt and dispensed solution. If the operator stops moving,
the machine will automatically raise the scrub deck and turn off the brushes. If the directional
switch is changed to reverse the machine will continue to operate normally, only the rear
squeegee will raise up.
2. HEAVY SCRUB MODE
This mode is similar to Regular Scrub. The machine will continue to operate the same was as
if it was in Regular Scrub Mode, only this mode applies more solution and brush pressure is
increased. This mode is used for high traffic areas and areas that have been heavily soiled, but
do not require time for the solution to soak.
3. DOUBLE SCRUB MODE
When the machine is running in this mode, the machine will perform all operations except
dirty solution recovery. This mode can be used if the floor is heavily soiled and the chemical
will need additional time to emulsify grease and oils that are on the floor. When the operator
sets the directional switch to either the forward or reverse position and activates the
accelerator lever, the solution pump will turn on, the brushes will turn on and be lowered to
the floor. While operating in this mode, the solution will be dispersed into the brushes, which
will scrub the floor allowing the chemical in the solution to break down the dirt on the floor.
As the machine continues to move forward or back, the rear squeegee and vacuum system are
not on, which allows the solution to stay on the floor emulsifying the grease and oil. If the
operator stops moving in either direction, the machine will automatically raise the scrub deck
and turn off the brushes. After double scrubbing, the operator should use the vacuum only
mode to recover the dirty solution water from the floor.
To Next Page
