Appendix
TX3 MiEntry Manual 23
Copyright 2020
4.4 Advanced Settings on iOS
1. On the Settings screen, tap Advanced.
Figure 24. Advanced settings on iOS
• Transport. Tap to change the transport. The default is TCP.
• Open Door Digit. MiEntry sends a DTMF signal to the TX3 Nano
or TX3 Touch Screen to open the door. By default, this is 9 in the
TX3 Nano, TX3 Touch Screen, and MiEntry. If this number is
changed in the TX3 Nano or TX3 Touch Screen, then you must also
change it here
• Debug. By default, this is set to None. If this setting is On, MiEntry
records information that can be used by Mircom technical support
to resolve issues.
• Send Logs. Tap to open an email message to
techsupport@mircomgroup.com containing the debug
logs.
• Clear Logs. Tap to erase any debug logs that MiEntry has recorded
To Next Page
Loading...
