Warranty and Warning Information
TX3 MiEntry Manual 29
Copyright 2020
15. Failure to Trigger Sensors. Moreover, Mircom Systems may fail to
operate as intended if motion, heat, or smoke sensors are not triggered.
a. Sensors in a fire system may fail to be triggered when the fire is
in a chimney, walls, roof, or on the other side of closed doors.
Smoke and heat detectors may not detect smoke or heat from fires
on another level of the residence or building. In this situation the
control panel may not alert occupants of a fire.
b. Sensors in a nurse call system may fail to be triggered when
movement is occurring outside of the motion sensors’ range. For
example, if movement is occurring on the other side of closed
doors or on another level of the residence or building the motion
detector may not be triggered. In this situation the central
controller may not register an alarm signal.
3. Interference with Audible Notification Appliances. Audible
notification appliances may be interfered with by other noise sources such
as stereos, radios, televisions, air conditioners, appliances, or passing
traffic. Audible notification appliances, however loud, may not be heard
by a hearing-impaired person.
4. Other Impairments. Alarm notification appliances such as sirens, bells,
horns, or strobes may not warn or waken a sleeping occupant if there is an
intervening wall or door. It is less likely that the occupants will be alerted
or awakened when notification appliances are located on a different level
of the residence or premise.
5. Software Malfunction. Most Mircom Systems contain software. No
warranties are provided as to the software components of any products or
stand-alone software products within a Mircom System. For a full
statement of the warranties and exclusions and limitations of liability
please refer to the company’s standard Terms and Conditions and
Warranties.
6. Telephone Lines Malfunction. Telephone service can cause system
failure where telephone lines are relied upon by a Mircom System. Alarms
and information coming from a Mircom System may not be transmitted if
a phone line is out of service or busy for a certain period of time. Alarms
and information may not be transmitted where telephone lines have been
compromised by criminal tampering, local construction, storms or
earthquakes.
7. Component Failure. Although every effort has been made to make this
Mircom System as reliable as possible, the system may fail to function as
intended due to the failure of a component.
8. Integrated Products. Mircom System might not function as intended if it
is connected to a non-Mircom product or to a Mircom product that is
deemed non-compatible with a particular Mircom System. A list of
compatible products can be requested and obtained.
To Next Page
Loading...
Need help?
General
