Page 47
Are you sure?
[*=CANCEL][#=OK]
Are you sure?
[*=CANCEL][#=OK]
[0] [0=NS,1=BN,2=BDC]
IMPORTANT
Before entering any data into the system, the following three steps must be performed
in order to initialize the system properly.
1. Before you enter resident names and dial codes or do anything, move the arrow to Init/Erase all
data, you will see the following screen,
press #, this will erase all data, initialize the system and add all the default values and returns to
the Opening Screen (acts as an ON/OFF switch).
2. Next move the arrow to Initialize Logging, you will see the following screen,
press the # key and this will eliminate all present logging.
Preform these two functions first, before entering any data into the TAS-2000.
3. Auto Sort Order
Place arrow on the Auto Sort Order function and press 0 to select and the next screen will be:
NS= NO SORT
BN= BY NAME
BDC= BY DIAL CODE
Select the type of sorting required, for example if sorting alphabetically by name enter the digit 1 (by
pressing the 1 key) and then press # key to accept this and move back to the programming menu. Reset
the system at this point, prior to adding names. By doing this, whatever data you now enter will
automatically be sorted in the order in which it was programmed above (i.e. by name in this example) and
is not affected by the power on or off of the system.
If the Auto Sort Order was not selected prior to
entering names, then in the case of power failure, the names will return to the order of entry.
To Next Page
Loading...