Registration and Configuration
Battery Specification
Technology: Nickel-metal-hydride (NiMH)
Size: AAA (Micro, HR03)
Voltage: 1.2 V
Capacity: 400–800 mAh
The following types of battery are recommended:
• GP GP55AAAHCR 550mAh
• SHP HFR-44AAAJ550 550mAh
• SUPPO HSY-AAA0.55-C 550mAh
The handset is supplied with the recommended batteries.
Charging the Handset
It is recommended that you charge the handset battery fully before first use.
1. Charge the battery. It takes approximately 8 hours to fully charge the battery.
2. Then remove the handset for use.
Care of the Handsets
Wipe the charging cradle and the handset with a damp cloth (do not use solvent) or an antistatic
cloth. Never use a dry cloth. This can cause static.
If the handset should come into contact with liquid:
• Switch the handset off and remove the batteries immediately.
• Allow the liquid to drain from the handset.
• Pat all parts dry, then place the handset with the battery compartment open and the keypad
facing down in a dry, warm place for at least 72 hours (not in a microwave, oven etc.).
• Do not switch on the handset again until it is completely dry.
When it has fully dried out, it can be used again.
To Next Page
Loading...
