Mitsubishi Electric FX3U-232-BD - Applicable FX PLC and Communication Equipment

E-18
FX Series PLC User's Manual - Data Communication Edition
Inverter Communication
3 System Configuration and Selection
3.2 Applicable FX PLC and Communication Equipment
3.2 Applicable FX PLC and Communication Equipment
Select a (optional) communication equipment combination, and put a check mark in the "Check" column.
During selection, pay attention to the following:
-
In the table below, only the external dimensions are different between the units shown in "FX 2NC -485ADP/
FX
0N -485ADP". Select either one.
- In the table below, only the cable is different between the units shown in "FX
3G-485-BD/FX3G-485-BD-
RJ". Select either one.
- Inverter communication is not provided for the FX
1, FX2(FX), FX2C, FX0, FX0S, FX0N, FX1S, FX1N and
FX
1NC PLCs.
FX Series Communication equipment (option)
Total
extension
distance
Check
50 m
(164' 0")
500 m
(1640' 5")
FX
3S
50 m
(164' 0")
500 m
(1640' 5")
FX
3G
(14-point, 24-point type)
50 m
(164' 0")
500 m
(1640' 5")
FX2N-ROM-E1
(Function extension
memory cassette)
FX2N
+
FX 2N -485-BD
FX 2N -CNV-BD
+
FX 2NC -485ADP
(European terminal block)
FX 0N -485ADP
(Terminal block)
FX 2N -CNV-BD
+
FX3G-485-BD
(European terminal block)
FX3G-485-BD-RJ
(RJ45 connector)
FX 3S-CNV-ADP FX 3U -485ADP(-MB)
(European terminal block)
+
FX3G-485-BD
(European terminal block)
FX3G-485-BD-RJ
(RJ45 connector)
FX3G-CNV-ADP FX3U-485ADP(-MB)
(European terminal block)