Mitsubishi Electric FX3U-232-BD - Setting at Command for Unregistered Modem

I-35
FX Series PLC User's Manual - Data Communication Edition
Remote Maintenance
5 How to Setup Modems on the PLC Side
5.2 Setting Using FXGP/WIN
A
Common Items
B
N:N Network
C
Parallel Link
D
Computer Link
E
Inverter Communication
F
Non-Protocol Communication (RS/RS2 Instruction)
G
Non-Protocol Communication (FX
2N
-232IF)
H
Programming Communication
I
Remote Maintenance
Apx.A
Discontinued models
5.2.3 Setting AT command for unregistered modem
Only when "User entry mode" is selected in "Modem initialize", execute the following setting.
(The modem initialization setting depends on the setting contents of the window displayed when [Option]

[PLC’s mode setting] is selected from the toolbar.)
1 Displaying the device list
Select [View]  [Register view] from the toolbar.
2 Executing the display setting
Select the set items as shown in the table below, and click the [OK] button.
The device (data register) number to be set varies depending on the PLC as shown below:
PLC Device range
FX
1N/FX1NC/FX2N/FX2NC/FX3G/FX3GC/FX3U/FX3UC PLC D1000 to D1059
FX
1S/FX3S PLC D200 to D255
Item Contents of setting
Display form Line
Data size 16bit