Mitsubishi Electric FX3U-232-BD - Communication Setting in Parameter Method (FXGP;WIN)

A-69
FX Series PLC User's Manual - Data Communication Edition
Common Items
3 Outline of Communication Setting in the FX Series
3.3 Communication Setting in Parameter Method (FXGP/WIN)
A
Common Items
B
N:N Network
C
Parallel Link
D
Computer Link
E
Inverter Communication
F
Non-Protocol Communication (RS/RS2 Instruction)
G
Non-Protocol Communication (FX
2N
-232IF)
H
Programming Communication
I
Remote Maintenance
Apx.A
Discontinued models
3.3 Communication Setting in Parameter Method (FXGP/WIN)
Communication settings may be changed by the parameter method with GX Works2, GX Developer,
FXGP/WIN for Windows and FX-30P handy programming panel. This section describes how to change
parameters with FXGP/WIN.
Ch0 and Ch 2 cannot be set using FXGP/WIN.
 For details on GX Works2 operating procedure, refer to section 3.2.
For details on GX Developer operating procedure, refer to GX Developer Operating Manual.
For details on FX-30P operating procedure, refer to FX-30P Operation Manual.
3.3.1 Operating procedure
This subsection explains the serial communication setting method. Suppose that FXGP/WIN is already
started up.
1 Adjusting serial setting (parameter)
Select [Option]  [Serial setting (parameter)] from the toolbar.
The following dialog appears according to absence/presence of parameter settings.
1. When there are no parameter settings
There is no communication setting.
When using the programming communication, parallel link, N:N Network or remote maintenance, click the
[No] button.
When using computer link, inverter communication, or non-protocol communication (RS instruction) function,
click the [Yes] button.