Mitsubishi Electric FX3U-232-BD - Communication Setting Using Parameter Method (FXGP;WIN)

F-43
FX Series PLC User's Manual - Data Communication Edition
Non-Protocol Communication (RS/RS2 Instruction)
5 Communication Setting in FX Programmable Controller
5.3 Communication Setting Using Parameter Method (FXGP/WIN)
A
Common Items
B
N:N Network
C
Parallel Link
D
Computer Link
E
Inverter Communication
F
Non-Protocol Communication (RS/RS2 Instruction)
G
Non-Protocol Communication (FX
2N
-232IF)
H
Programming Communication
I
Remote Maintenance
Apx.A
Discontinued models
5.3 Communication Setting Using Parameter Method (FXGP/WIN)
Communication settings may be changed via the parameter method with GX Works2, GX Developer,
FXGP/WIN for Windows and FX-30P handy programming panel. It is not possible to set ch0 in FX
3G and
FX
3GC PLCs using parameters. This section describes how to change parameters with FXGP/WIN.
Ch0, ch2 cannot be set using FXGP/WIN.
For details on GX Works2 operating procedure, refer to section 5.2.
For details on GX Developer operating procedure, refer to GX Developer Operating Manual.
For details on FX-30P operating procedure, refer to FX-30P Operation Manual.
5.3.1 Operating procedure
This subsection explains the serial communication setting method. Suppose that FXGP/WIN is already
started up.
1 Displaying serial setting (parameter)
Select [Option]  [Serial setting (parameter)] from the toolbar.
The following dialog box appears according to absence/presence of the parameter settings.
1. When there is no parameter setting
There is no communication setting. Click the [Yes] button.