Mitsubishi Electric FX3U-232-BD - Fx 1 Nc; 16 Ccl; Fx 2 N -32 Asi; Fx 2 N -32 Ccl *4

A-60
FX Series PLC User's Manual - Data Communication Edition
Common Items
2 Communication Types and Communication Equipment
2.3 Combination of Communication Equipment (Block Diagram)
*1. The FX2N-16CCL-M cannot be used at the same time with the FX2N-32ASI-M.
*2. The FX
2N-32ASI-M cannot be used at the same time with the FX2N-16CCL-M.
Limitation in the number of connectable units
Connected special function units/blocks operate using the 24V DC or 5V DC power supply of the PLC.
Accordingly, the number of connectable units depends on the system configuration.
For details, refer to the respective FX PLC manual.
FX1NC Series
A
C
Up to 2 units can be selected.
CC-Link
For master
station
For remote
device station
CC-Link/LT
C
FX
2N
-16CCL-M
*1
FX
2N
-32CCL
C
FX
2N
-64CL-M
C
FX
2N
-16LNK-M
C
M3.5 terminal block
M3 terminal block
Dedicated connector
M3 terminal block
MELSEC-I/O LINK
C
FX
2NC
-CNV-IF
E
R
R
O
R
CC-Link
FX
2N
-16CCL-M
For special adapters with communication type , refer to the
previous page.
A
and indicate the mounting position.
A C
(For the mounting procedure, refer to the respective communication equipment manual.)



FX
2N
-32ASI-M
*2
C
FX
2N
-32ASI-M
POWE
R
U
ASI
ASI
ACTIVE
PRJ
MODE
PRG
ENABLE
FROM/
TO
CONFIG
ERR
MOD
E
SE
T
ADDRESS/
ERROR
M3 terminal block
AS-i system
