Mitsubishi Electric MELDAS MDS-B-SVJ2 Series - Explanation of each Part; Explanation of each Servo Amplifier Part

Chapter 1 Preface
1-7
1-2 Explanation of each part
1-2-1 Explanation of each servo amplifier part
D
C
P
L21
L11
D
C
P
L21
L11
N
L1 L2 L3
U V W
MDS-B-SVJ2-01
MDS-B-SVJ2-06
MDS-B-SVJ2-07
MDS-B-SVJ2-01
MDS-B-SVJ2-07
L11 L21
DP C
N
L1 L2 L3
UV W
MDS-B-SVJ2-10
MDS-B-SVJ2-20
～
～ ～
Absolute position detection battery
Absolute position detection battery holder
Absolute position detection battery connector
Display section : The operation status and alarms are displayed.
Axis No. setting rotary switch
Installation screw hole
Display setting section cover
CN1A
NC bus connector
CN1B
NC bus connector
CN2
For motor end detector connection connector
CN3
Magnetic brake control output, contactor
control output, D/A output connector
Charge lamp
This indicates that a high voltage is applied
in the amplifier (main circuit capacitor).
When this lamp is lit, do not touch the
terminal block or connect/disconnect the
cables and connectors.
Terminal block cover
Grounding terminal
Connect the grounding wire
Main circuit terminal block
Connect the main circuit power supply and motor power supply wire.
(In the SVJ2-10 and 20, this includes the control power supply and
regeneration option.)
Control power supply connector
Connect the control power supply and regenerative option.
1-2-2 Explanation of each servomotor part
HC, HCR, HAN HA-FF, HC-MF Series
HC-SF, HC-RF Series
Motor shaft
Power connector
Detector connector
Detector
Power cable
Detector cable
Detector
Motor shaft