Mitsubishi Electric Melsec A Series - 4.4 Switch Settings Comparisons

4 - 14
REPLACEMENT OF THE MELSECNET/10 (PLC TO PLC NETWORK)
4
: Compatible, : Partial change required, ×: Incompatible
*1 The QnA/QnAS series support the loop test.
4.4 Switch Settings Comparisons
Switch name
Description
Compat-
ibility
Precautions for replacement
A/AnS/QnA/QnAS series
MELSECNET/10 module
Q series
MELSECNET/H module
(MELSECNET/10 mode)
Network No.
setting switch
Sets the network No. -
• Set in GX Works2 or GX
Developer network
parameters.
• Network No.240 to No.255
cannot be set.
• Alternate them with unused
network Nos.
Group No.
setting switch
Sets the group No. -
Set in GX Works2 or GX
Developer network parameters.
Mode setting
switch
Sets the mode.
<Setting range>
0: Online
2: Offline
3: Loop test (forward loop)
*1
4: Loop test (reverse loop)
*1
5: Station-to-station test
(master station)
6: Station-to-station test
(slave station)
7: Self-loopback test
8: Internal self-loopback test
9: H/W test
D: Network No. check
E: Group No. check
F: Station No. check
Sets the mode.
<Setting range>
0: Online
1: Self-loopback test
2: Internal self-loopback test
3: hardware test
• Set offline, loop test and
station-to-station test in GX
Works2 or GX Developer
network parameters.
• Check network No., group
No. and station No. in GX
Works2 or GX Developer
network diagnostics (host
information).
Condition setting
switch
Sets the operation conditions. -
This switch cannot make
parameter setting.
Set in GX Works2 or GX
Developer network parameters.