Mitsubishi Electric Melsec A Series - Parameter Setting Example; Parameter Setting Example on the A;Ans Series

REPLACEMENT OF CC-LINK
6 - 25
6
The following describes an example how to replace the system in which parameters were set using
sequence program (TO instruction) on the A/AnS series with the system in which parameters are set
using GX Works2 or GX Developer on the Q series.
This section explains the above using the following system configuration example.
6.8.1 Parameter setting example on the A/AnS series
The following shows a program example of parameter setting using the sequence program (TO
instruction).
6.8 Parameter Setting Example
Master
station
(X/Y00 to 1F)
Remote
I/O station
(Occupies
1 station)
Intelligent
device station
(Occupies
4 stations)
Local
station
(Occupies
4 stations)
Station No.1
Station No.2
Station No.8
Station No.9
Station No.4
Remote
device station
(Occupies
2 stations)
Reserved
station
(Occupies
1 station)
Module
error
Module
ready
Number of stations
5 stations
Number of stations
5 stations
Number of retries
5 times
Reserved station specification
Station No. 8
Reserved station
specification
Station No. 8
Number of automatic return modules
2 modules
Stop at CPU failure
Stop at
CPU failure