Mitsubishi Electric Melsec A Series - Page 58

REPLACEMENT OF MELSECNET (II) AND /B (PLC TO PLC NETWORK)
2 - 21
2
(c) MELSECNET/H normal station
1) Network parameter setting
The network parameter settings of MELSECNET/H normal stations (Q02UCPU) are the same as
those of MELSECNET/H normal stations when replaced with the MELSECNET mode. (Refer to
the Section 2.5.2 (1) MELSECNET mode.)
2) Station inherent parameter
For the station inherent parameter settings, settings of the same content as that for the control
stations has to be set to all normal stations.
3) Refresh parameters
The same parameter settings are required on all normal stations.
Station inherent parameter (Q02UCPU: MELSECNET/H normal station)
Refresh parameters (Q02UCPU: MELSECNET/H normal station)