Mitsubishi Electric Melsec A Series - Page 83

2 - 46
REPLACEMENT OF MELSECNET (II) AND /B (PLC TO PLC NETWORK)
2
Network parameter setting is required for control and normal stations on MELSECNET/H.
The following shows parameters required on each station of MELSECNET/H.
: Setting required/ : Setting required (Default setting is also acceptable)/ - Setting not required
Common parameter
(Network range
assignment)
Station inherent parameter Refresh parameter Inter-link data transfer
1Mp3
(Refer to example in (e) 2)) (Refer to example in (e) 3)) (Refer to example in (e) 4))
1Ns2
(Refer to example in (f) 2)) (Refer to example in (f) 3))
1Ns1 -
(Refer to example in (g) 3))
(Refer to example in (g) 5))
2Mp3
(Refer to example in (g) 2))
-
(Refer to example in (g) 4))
2Ns1
(Refer to example in (h) 2)) (Refer to example in (h) 3))
2Ns2
(Refer to example in (h) 2)) (Refer to example in (h) 3))