Mitsubishi Electric MELSEC FX2NC-16MT-D/UL - Page 27

FX2NC Series Programmable Controllers Introduction 1.
1-15
Connection of FX
0N
and FX
2N
series extension blocks and function adapter
To connect the FX
2NC
series main unit to the FX
0N
or FX
2N
series extension blocks, be sure to
connect the FX
2NC
-CNV-IF connector conversion adapter first. Following the adapter, you can
connect up to 4 blocks. In addition, one special adapter can be connected to the left side of the
base unit. Before connection, calculate the number of connectable input/output points by refer-
ring to Sec. 1.5.3.
FX
2NC
-32MT
-D/UL
FX
0N
-232ADP (Function adapter)
FX
2NC
Series
extension blocks
FX
2NC
-CNV-IF (Connector conversion adapter)
FX
2N
-16EYR
-ES/UL
relay output
block
FX
2N
-232IF
RS-232C
block
FX
2N
-1PG-E
pulse output
block
FX
2N
-4AD
analog block
4 blocks, maximum