Mitsubishi Electric MELSEC FX2NC-16MT-D/UL - Termination of Connector Style I;O Cables

FX2NC Series Programmable Controllers Installation notes 3.
3-20
3.14 Termination of connector style I/O cables
Standard, pre-terminated cables are available from Mitsubishi in 1.5, 3 and 5 meter (4.9, 9.8
and 16.4 ft) lengths. However, users are encouraged to make their own cables to the lengths
they require. The following table identifies connectors and cable requirements;
Table 3.5 :
( ): ft
MODEL LENGTH
n o p q
FX-16E-500CAB-S 5m (16.4)
20 Pin
connector
No connector Single wire Input switch or Loads
FX-16E-150CAB 1.5m (4.9)
20 Pin
connector
20 Pin
connector
Flat cables
TERMINAL BLOCK
x
FX-16E-TB
x
FX-32E-TB
x
FX-16EX-A1-TB
x
FX-16EYR-TB
x
FX-16EYT-TB
FX-16E-300CAB 3m (9.8)
FX-16E-500CAB 5m (16.4)
FX-16E-150CAB-R 1.5m (4.9)
20 Pin
connector
20 Pin
connector
Round
cables
FX-16E-300CAB-R 3m (9.8)
FX-16E-500CAB-R 5m (16.4)
FX
2NC
n op q
Figure 3.15: