FX2NC Series Programmable Controllers Installation notes 3.
3-17
3.11 Wiring techniques
The wiring of FX
2NC
products has been designed to be safe and easy. If during the installation
of these products or associated products concern is felt, please contact a professional electri-
cian who is trained to the local and national standards applicable to the installation site.
Wiring cautions
• Do not run input signals in the same multicore cable as output signals or allow them to
share the same wire.
• Do not lay I/O signal cables next to power to power cables or allow them to share the
same trunking duct. Low voltage cables should be reliably separated or insulated with
regard to high voltage cabling.
• Where I/O signal lines are used over an extended distance consideration for voltage
drop and noise interference should be made.
To Next Page
Loading...
