Mitsubishi Electric MELSEC iQ-R Series - Installation of Modules

To Next Page

To Previous Page

2 MODULE STARTUP

2.4 Installation of Modules

Install the modules.

1. Installing a battery

The connector plug of the Q6BAT is disconnected from the jack of the CPU module before shipment. To use the battery,

connect the connector, following the procedure below.

1. Open the battery cover located on the bottom of the CPU module.

2. Check that the Q6BAT (1) is correctly installed.

3. Check the direction and securely insert the connector plug of the Q6BAT (2) to the jack (3) of the CPU module.

4. Close the battery cover.

2. Inserting an extended SRAM cassette and a SD memory card

Since the example system does not use an extended SRAM cassette and a SD memory card, the insertion/removal

procedures are omitted in this document.

Refer to MELSEC iQ-R CPU Module User's Manual (Startup) for details.

3. Installing a module

Install each module to the main base unit.

Refer to MELSEC iQ-R Module Configuration Manual for details.

View video:

Other manuals for Mitsubishi Electric MELSEC iQ-R Series