Mitsubishi Electric MELSEC iQ-R Series - Cam Data Creation

58
4 SYNCHRONOUS CONTROL STARTUP
4.3 Parameter Creation for Synchronous Control
4.3.5 Cam data creation
1. Creating a new cam data
1. Right click on [Cam Data], and select [Add New Data…] to open the New Data window.
2. Set the cam No.
3. Select "Set by Stroke Ratio" and "Cam Curve" in the Setting Method.
4. Click [OK]. The cam data creation screen appears.
5. Make a rough cam graph by dragging an end of the cam waveform.
6. Based on the rough cam data, modify the end point and stroke to finish the cam data.
View video:
1.
2.
3.
4.
5.
6.