Mitsubishi Electric MELSEC iQ-R Series - Page 59

4 SYNCHRONOUS CONTROL STARTUP
4.3 Parameter Creation for Synchronous Control
57
4
3. Transition of synchronous control parameter window
1. Select [Axis #1 Synchronous Parameter] from the menu.
Axis #1 synchronous parameters can now be set.
2. Click [Synchronous Control Image] to open the image screen.
3. Select the main shaft to open the input axis parameter.
Parameters related to the input axis (Axis 2) can now be set.
4. Settings for synchronous control parameters and input axis parameters are completed.
1.
[Synchronous parameter]
[Input axis parameter]
2.
3.